- Used to remove nylon male from the metal denture cap
- Sharp circular edge of the removal tool should be wedged tightly down into the very bottom of the plastic male so that it will catch the inside of the plastic insert and pull it at an angle out of the metal housing
- Prior to use, loose the tip 3 full turns counter-clockwise (You will see a visible gap
- To discard the nylon male from the tip of the core tool:
- Point the tool down and away from you
- Tighten the Male Removal Tool Clockwise back onto the core tool
- Removal pin will then be activated and dislodge the nylon male from the tip end
